Subscribe
Copied to clipboard
Share
Share
Copied to clipboard
Embed
Copied to clipboard
Circuit Break - A MacroFab Podcast
Trailer
Bonus
Episode 158
Season 1
EP#158: Jason Cerundolo of Reclaimer Labs
- Jason Cerundolo
- An engineer experienced in mechanical, electrical, and firmware engineering
- Jason has over nine years of experience as a hardware engineer and working on electronic designs in Silicon Valley
- In his free time, he works on open source projects, such as USB Type-C tools and projects
- USB Type-C Power Delivery PHY Breakout Board
- A breakout board for the FUSB302
- USB-PD PHY for BMC communication used in USB-C connectors
- Determine plug orientation (normal or reversed)
- Determine or advertise Type-C power levels (5 V at 0.5, 1.5, or 3.0 A)
- Use BMC communication to negotiate USB Power Delivery Explicit Contracts up to 20 V and 5 A (100 W of power)
- Negotiate Alternate Modes to reuse the pins in the Type-C connector for other purposes
- A breakout board for the FUSB302
- One of the problems that I always run into with USB designs is the “Am I doing this right?”
- Testing, debugging, and evaluation
- What hardware and software should you look at when building a test setup for USB?
- Low Cost Alternatives for home designers and startups?
- Jason has some tools like the FUSB302 break out board and USB-C Explorer
- Teledyne LeCroy Mercury T2C USB HS/PD Protocol Analyzer
- Cypress CY4500 EZ-PD Protocol Analyzer
- Testing, debugging, and evaluation
- What is a good place to start if a hardware designer wants to get into USB Type-C?
- Jason has articles that cover a solid foundation of USB Type-C in his USB-C for Engineers, Part 1
- Reclaimer Labs
- Quick hardware layout tips for USB signals
- Standard high speed signal routing applies
- For USB 2.0 just keeping them the same length should be enough
- For Superspeed USB 3.0+ length matching for each pair is more important
MacroFab will be at SXSW. We are teaming up with Particle.io to put together a Hardware Happy Hour. It will take place on Friday March 8th from 4PM until 8PM at the super cool Jester King Brewery. Check the show notes for full details and to RSVP. Join us for lite bites and refreshments, network with fellow Hardware nerds and kick off SXSW.